S8 Quattro Sedan V8-4.2L (AYS) (2002)
^
The lower spring support has a groove.
^
This groove is to be inserted in the lug at the trapezium link.
^
Turn end of coil spring until it makes contact with lower spring support.
^
Then turn upper spring support (not shown) until it makes contact with top end of spring.
^
Slacken off spring.
^
Bolt brake caliper to wheel bearing housing:
^
Tighten collar bolt to 190 Nm (140 ft. lbs.) plus additional 180° turn.
WARNING! To reduce the risk of accident, vehicle must be standing on the ground when loosening and tightening collar bolt.