S8 Quattro Sedan V8-4.2L (AYS) (2002)
Wheel Bearing: Service and Repair
Wheel Bearing Housing (Bearing Pressed In), Servicing
Rear Wheel Bearing Housing (Bearing Pressed In), Servicing
1 - Wheel bearing housing
^
Removing and installing, Refer to Removing and Installing Wheel Bearing Housing.
2 - Sleeve
^
Before inserting in wheel bearing housing, grease all around with brake cylinder paste G 000650
^
Press home in wheel bearing housing
3 - Speed sensor
4 - Bonded rubber bushing
^
Always replace bushings on both sides of vehicle
^
Extracting, Refer to Figs. 6 through 8
^
Installing, Refer to Fig. 9
5 - Wheel bearing
^
Stepped internal diameter
^
Installation position: larger diameter of wheel bearing faces wheel hub
^
Pressing out, Refer to Fig. 2
^
Pressing off bearing inner race, Refer to Fig. 3
^
Pressing in, Refer to Fig. 4
6 - Splash plate
7 - Hex bolt, 10 Nm (7 ft. lbs.)
8 - Hub
^
Stepped design
^
Pressing out, Refer to Fig. 1
^
Pressing in, Refer to Fig. 5