S8 Quattro Sedan V8-4.2L (AYS) (2002)
Flex Plate: Service and Repair
Dual-mass flywheel or drive plate, removing and installing
A - Dual-mass flywheel (M/T)
-
With crankshaft at Top Dead Center (TDC), install 3242 crankshaft holder.
-
Mark position of dual-mass flywheel and engine cylinder block (arrows).
-
Remove bolts.
Note: Replacement dual-mass flywheels are not supplied with the pilot needle bearing installed. When replacing the flywheel, always install a
new pilot needle bearing.
Tightening Torques (Part 16 Of 18)
Tightening Torques
Note: Always replace dual-mass flywheel mounting bolts.
B - Drive plate (A/T)
-
Hold crankshaft in position using 3242 crankshaft holder.
-
Mark positions of shim -1- (in front of drive plate) and washer -2- (behind drive plate).