S8 Quattro Sedan V8-4.2L (AYS) (2002)
Windshield: Removal and Replacement
Windshield, Installing
Windshield, Installing
Preparation For Windshield Installation
NOTES:
-
When reusing an undamaged window, cut the remaining adhesive sealing material on the window and flange evenly using a carpet knife, but do
not remove the adhesive completely.
-
Leftover adhesive material is required as a base for better adhesion of the new adhesive sealing material.
-
Keep surface free of dirt and grease.
-
If the window flange is damaged during the removal procedure, the paint structure should be repaired, and if necessary, corrosion prevention
measures should be carried out.
-
Areas with residual adhesive bead must not be treated with the cleaning solution and primer.
Reworked (replaced) Windshield Flange
-
Apply 1-component primer LGF 008 001 A2 to the bare metal.
-
After priming, apply top coat with hardener to appropriate area.
NOTE: Top coat must be hardened before primer is applied.
-
After paint application, the improved area must be newly cleaned and primed as appropriate using glass/paint primer D 009 200 02.
CAUTION: Glass/lacquer primer D 009 200 02 is electrically conductive and must never be applied to bare aluminum. CONTACT
CORROSION.
All
-
Clean new window all around adhesive area using glass cleaner.
Applying Primer
NOTE: Ceramic application on window is not primer. Before applying adhesive sealing materials, primer must always be applied to new windows.
-
Apply primer - 2 - evenly in one motion using applicator - 1 -.
-
Begin application with felt fully saturated.
-
Drying time approx. 10 minutes.
-
Primer dimension - a -: 20 mm (3/4 in.)
-
Apply primer to center of adhesive sealing material.
NOTE: Do not touch up primer strip until after primer has thoroughly dried.
Applying Primer And Adhesive Bead To Straight Edge Of Windshield