TT L4-18L Turbo (BEA) (2004) - Navigation Module Service and Repair - Coupe
Navigation Module: Service and Repair
Roadster
Control Module For Navigation With CD- Mechanism -J401- (Roadster), Removing And Installing
The control module for navigation is located in the rear panel behind the passenger seat.
Removing
-
Open right storage compartment behind passenger seat.
-
Remove right storage compartment (with navigation).
-
Remove mounting bolts -2- (2 Nm) at installation frame.
-
Remove installation frame -4-.
-
Disconnect electrical harness connectors and antenna wire (GPS) at rear of control module for navigation with CD drive.
-
Unscrew the four mounting screws -6- (2 Nm) at left and right at control module for navigation with CD drive -7-, and remove it from the
installation frame -4-.
CAUTION: Use only original bolts when securing control module. Otherwise, the control module may be destroyed.
Installing
-
Install in reverse order of removal.
Notes for installation:
-
The control module for navigation and the installation frame must be installed together in a horizontal position and free from vibration to avoid
system trouble.
-
The ventilation slots of the control module may not be covered once installed.