TT Coupe L4-1.8L Turbo (AWP) (2005)
Ignition Switch Lock Cylinder: Service and Repair
Lock Cylinder, Removing and Installing
Lock Cylinder, Removing And Installing
CAUTION:
Before beginning repairs on the electrical system:
-
Obtain the anti-theft radio security code.
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Disconnect negative ( - ) battery terminal.
-
When reconnecting battery terminals, observe all applicable Notes and torque specifications, as well as instructions on performing OBD
program and electrical system function checks as specified.
WARNING: Special safety precautions apply to vehicles equipped with airbags. Refer to Body-Interior, Airbag: CAUTIONS and
WARNINGS.
NOTE:
-
On vehicles with anti-theft immobilizer, the reader coil is attached to lock cylinder and cannot be replaced separately.
-
Lock cylinder must be replaced if reader coil malfunctions.
Removing
-
Remove steering column switches.
-
Where applicable, disconnect electrical connection at reader coil.
Vehicles with automatic transmission:
-
Shift selector lever to "P".
-
Turn ignition key to "Ignition ON" position -arrow-.
-
Lift interlock lever -1- slightly and pull interlock cable -2- out of ignition lock housing.
All models:
NOTE: Spare key is required for removal of lock cylinder as the following operations can only be performed with an ignition key with a flat grip, i.e. no
light and no remote control.
-
Turn spare key to "ignition ON" position, thus aligning recess in trim -arrow- with hole in ignition lock.
NOTE: Illustration shows correct lock position without ignition key.