TT Coupe L4-2.0L Turbo (BPY) (2008)
Carpet: Removal and Replacement
Floor Covering, Removing and Installing
Floor Covering, Removing And Installing
Removing
-
Remove left and right front seat.
-
Remove rear seat bench.
-
Remove drivers side instrument panel cover.
-
Completely remove center console.
-
Remove accelerator pedal module.
-
Remove push knobs - 1 - and remove steering opening cover.
-
Remove lower A-pillar trim on left and right.
-
Remove left and right sill panel strip.
-
Remove base support cover.
-
Remove anchorage point for front outer floor assembly.
-
Remove expanding clips - 2 - (Qty. 8).
-
Disengage floor mat at retainers - 1 -.
-
Disengage floor mat at omega clips - 3 -.
-
Disengage wiring harness - 4 - and - 5 - from retainers.
-
Pull floor mat - 6 - toward rear.
NOTE: Ensure floor mat does not tear at openings.
-
Fold floor mat lengthwise, guide under wiring harness - 4 - and - 5 - and remove through a door.
Installing
Installation is reverse of removal. Observe the following when doing so:
-
Fold new floor mat lengthwise and place in vehicle.