TT Coupe L4-2.0L Turbo (BPY) (2008)
-
Remove screws - 1, 2, 4 -.
-
Pull wiper frame with linkage and wiper motor - 3 - slightly toward left in direction of travel.
-
Turn windshield wiper frame with the linkage and the wiper motor up so it can be pried out of wiring clip - 6 - with Pry Lever (80 - 200).
‹› For easier removal, use silicon-free lubricating spray.
-
Disconnect electrical connector - 5 -.
-
Remove windshield wiper frame with linkage and motor to left in direction of travel from plenum chamber.
Installing
‹› Tightening specification => [ Windshield wiper motor tightening sequence ] See: Wiper and Washer Systems/Service and Repair/Removal and
Replacement/Windshield Washer System Assembly Overview.
Install in reverse order of removal, observing the following:
-
Insert wiper motor with wiper frame into vehicle.
-
Tighten bolts => [ Windshield wiper motor tightening sequence ] See: Wiper and Washer Systems/Service and Repair/Removal and
Replacement/Windshield Washer System Assembly Overview.
-
Adjust wiper arms, refer to => [ Windshield Wiper Arms, Adjusting ] See: Wiper and Washer Systems/Wiper Arm/Adjustments.