TT Coupe L4-2.0L Turbo (BPY) (2008)
Drive/Propeller Shaft: Removal and Replacement
Driveshaft with Inseparable Center Support, from 05.2007, Installing
Driveshaft with Inseparable Center Support, from 05.2007, Installing
Install in reverse sequence; note the following points:
-
Install all parts marked to each other in original positions.
-
Install driveshaft on final drive so that both markings - arrows - align.
-
Tighten the driveshaft. Tightening specifications => [ (Item 4) Bolt ] See: Driveshaft with Inseparable Center Support, from 05.2007 Assembly
Overview and => [ (Item 9) Bolt ] See: Driveshaft with Inseparable Center Support, from 05.2007 Assembly Overview.
Install center bearing free of tension as follows:
‹› All driveshaft bolts are tightened.
-
Align the intermediate bearing in its elongated holes so the driveshaft or bearing is not under stress.
-
Tighten combi-bolt - 1 -. The combi-bolts - 1 - must lie inside the heat shield centering tabs - 2 -. Tightening specification => [ (Item 6) Bolt ]
See: Driveshaft with Inseparable Center Support, from 05.2007 Assembly Overview.
-
Tighten pendulum support with new bolts. Tightening specification. Refer to