TT Coupe L4-2.0L Turbo (BPY) (2008)
Constant Velocity Joint: Service and Repair
Drive Axle (With 100 mm Diameter Inner Constant Velocity Joint), Servicing
Drive axle (with 100 mm diameter inner constant velocity joint), servicing
Filling joints with grease
Note:
^
Grease joint again when replacing protective joint boot.
1. Outer constant velocity joint
^
Replace only as complete unit
^
When installing joint on axle shaft, splines on axle shaft must be lightly coated with grease used in joint.
2. Bolt
^
200 Nm plus an addition 1/2 turn (180 degrees)
^
Always replace after removal
^
Before installing, threads in constant velocity joint should be cleaned with a tap.
3. Axle shaft
4. Clamp
^
Replace
^
Tensioning or
5. CV boot for outer constant velocity (CV) joint
^
Without ventilation bore
^
Check for tears and scuffing