TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
-
Unplug connector from injector to be tested.
-
Connect multimeter to valve (resistance measurement range)
-
Specification: 12 to 13 Ohms (at room temperature)
If the specification is not attained:
-
Replace the injector.
If the specification is obtained:
-
Check voltage supply.
Checking voltage supply
Requirements for test:
-
Fuse for injectors OK.
-
Fuel pump relay OK.See: Computers and Control Systems/Testing and Inspection/Component Tests and General Diagnostics/Fuel Pump (FP)
Relay -J17-, Checking and Activating/With Manufacturer's Scan Tool
-
Unplug connector from injector to be tested.
-
Connect VAG 1527 B voltage tester as follows:
Connector
Measure against
Contact
1
Engine Ground
-
Switch on ignition.
-
The LED should light up.
If the LED does not light up:
-
Test for open circuit in wiring between contact 1 and fuse for injectors:
-
Correct any open circuits.
If the LED lights up:
-
Test activation of injectors.
Testing activation
Test requirement: