TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
-
Remove securing ring.
-
Place front and rear bearing tool - 1 - on rear side of wheel bearing.
-
Attach hollow piston cylinder - 2 - with tie bolt - 3 and special nut - 4 -.
-
Build pressure by pumping foot pump.
-
Check to make sure all tools are properly centered.
-
Press off wheel bearing by pumping.
1 - Front and rear bearing tool E - 5
2 - Hollow piston cylinder HKZ - 15
3 - Tie bolt E - O - 217
4 - Special nut E - 8 - 214
5 - Bell E - 44
-
Remove inner ring of bearing from wheel hub.
Pressing in wheel bearing
-
Place wheel bearing on wheel bearing housing.