TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
Pressing in wheel bearing
-
Install wheel bearing - 1 - thrust piece - 2 - (fit with collar in bearing) and hollow piston cylinder- 3 - with pull rod on wheel bearing housing.
-
Install thrust piece - 4 - (with wide collar toward wheel bearing housing) and special nut - 5 - on inside.
-
Press wheel bearing in by operating pump.
-
Insert circlip with long nose pliers.
1 - Wheel bearing
2 - Thrust piece E - 13 - 1
3 - Hollow piston cylinder HKZ - 15
4 - Thrust piece E -10
5 - Special nut E - 8 - 214 and pull rod
Pressing in wheel hub
-
Install hub - 1 - and hollow piston cylinder- 2 - with pull rod on wheel bearing.
-
Install special nut - 4 - and thrust piece - 3 - (with collar toward special nut) on inside.
-
Press in hub by operating pump.
1 - Hub
2 - Hollow piston cylinder HKZ - 15
3 - Thrust piece E - 5
4 - Special nut E - 8 - 214 and pull rod
When installing, note the following points in particular:
Notes: Observe Notes and go to Splines, Drive Axle/Wheel Hub
-
Clean splines/threads on drive axle.
-
Clean splines in hub.
-
Screw on new 1 2-point nut as far as possible.
-
Secure brake caliper to wheel bearing housing (125 Nm/92 ft. lbs.).
-
Secure coupling link to suspension strut (use new nut).
-
Lower vehicle, but ensure that the wheels do not touch the ground (otherwise the wheel bearing could be damaged).
-
Apply brakes (second person necessary).
-
Fully tighten 12 - point nut.