TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
Power Window Control Module: Customer Interest
Cause 1
(All TT models)
-
Perform "Basic setting for window regulator motor, clearing" (see AESIS Repair Manual, Body Exterior; Repair Group 64, Glass, Window
regulators, Door window, removing and installing).
With Basic setting cleared:
-
Perform "Basic setting for window regulator motor, activating" (see AESIS Repair Manual, Body Exterior; Repair Group 64, Glass, Window
regulators, Door window, removing and installing).
Note:
^
During procedure, doors must be closed and engine operating at idle.
^
The door window glass must contact upper door frame/(folding top) seal for window motor to "learn" the additional resistance.
With Basic setting activated:
-
Check that condition has been eliminated, verify all window functions.
-
Check and clear any stored DTCs.
If condition remains:
-
Verify power window components i.e. window channel / guide, window lifter (regulator), window seals are aligned, adjusted and properly secured.
When diagnosis leads to adjustments and / or replacement of door / window components:
-
Refer to AESIS Repair Manual, Body Exterior; Front doors, Central locking system, and subsequent sections for information.
After adjusting and / or replacing components
-
Perform "Basic setting for window regulator motor, clearing" again, (see AESIS Repair Manual, Body Exterior; Repair Group 64, Glass, Window
regulators, Door window, removing and installing).
With Basic setting cleared:
-
Perform "Basic setting for window regulator motor, activating" again, (see AESIS Repair Manual, Body Exterior; Repair Group 64, Glass, Window
regulators, Door window, removing and installing).
Note:
^
During procedure, doors must be closed and engine operating at idle.
^
The door window glass must contact upper door frame/(folding top) seal for window motor to "learn" the additional resistance.
With Basic setting activated:
-
Check that condition has been eliminated, verify all window functions.
-
Check and clear any stored DTCs.