TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
Power Window Control Module: Customer Interest
Cause 2
(TT Coupe only between VIN: 8N11046716 and 8N11048543)
-
Perform "Basic setting for window regulator motor, clearing" (see AESIS Repair Manual, Body Exterior; Repair Group 64, Glass, Window
regulators, Door window, removing and installing).
With Basic setting cleared:
-
Perform "Basic setting for window regulator motor, activating" (see AESIS Repair Manual, Body Exterior; Repair Group 64, Glass, Window
regulators, Door window, removing and installing).
Note:
^
During procedure, doors must be closed and engine operating at idle.
^
The door window glass must contact upper door frame/(folding top) seal for window motor to "learn" the additional resistance.
With Basic setting activated:
-
Validate door window operation with engine operating as follows:
Note:
Door window operation (opening/closing) must be performed using only the one-touch feature.
-
Open and close door window one time in one-touch mode.
^
Window must not reverse direction.
-
Lower window to half-open position.
-
Close window in one-touch mode.
-
Repeat above validation steps five (5) times.
When procedures mentioned do not resolve conditions, replacement of the power window motor will not resolve the issue.
The door / window components listed in table for the affected door must be replaced.