TT Quattro Coupe L4-1.8L Turbo (AWP) (2001)
Wiper Motor Linkage: Service and Repair
Wiper linkage & wiper motor, removing
CAUTION: Do not loosen or remove 13 mm A/F nut from wiper motor crank.
-
Pry off linkage rod -3- from ball joint -arrow-.
-
Remove bolts (10 mm A/F) -2- from wiper motor bracket.
-
Remove wiper motor -1 - from bracket.
Installing
-
Bolt wiper motor -1 - onto wiper motor bracket together with crank.
-
Engage linkage rod -3- again, adjusting end position of linkage at -a-.
-
Reconnect electrical connection to wiper motor.
-
Insert wiper frame (wiper motor first) into plenum.
-
Tilt wiper frame forward and bolt in position (5 Nm).
The remaining steps for installing are the same as for removing but in the reverse sequence.
-
Set wiper blades to park position.