TT Quattro Coupe V6-3.2L (BHE) (2005)
-
Switch the ignition on.
-
Using a Multimeter, check the Camshaft Adjustment Valve 1 N205 electrical harness connector terminal 1 to Ground (GND) for voltage.
-
Switch the ignition off.
Specified value: battery voltage.
If the specified value was not obtained:
-
Check the Camshaft Adjustment Valve 1 N205 electrical harness connector terminal 1 to the Motronic Engine Control Module (ECM) Power
Supply Relay J271 socket 2/87 for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specified value was obtained:
Checking wiring
If the manufacturers test box is being used. Perform the following step.
-
Install the test box VAG1598/31.
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Motronic Engine Control Module (ECM) J220.
-
Using a Multimeter, Check the Camshaft Adjustment Valve 1 N205 electrical harness connector terminal 2 to the Motronic Engine Control
Module (ECM) J220 electrical harness connector for resistance.
Camshaft Adjustment Valve
Motronic Engine Control Module (ECM)
1 N205 electrical
J220 electrical harness connector terminal
harness connector terminal
or test box socket
2
115
Specified value: 1.5 Ohms Max.
If the specified value was not obtained:
-
Check the wiring connection for an open circuit, short circuit to Battery (+) or Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If no malfunction is found in the wiring and voltage supply was OK:
-
Replace the Camshaft Adjustment Valve 1 N205.
-
Erase the DTC memory. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Mode 04 - Erase DTC Memory
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. See: Powertrain Management/Computers and Control Systems/Testing and Inspection/Initial Inspection and
Diagnostic Overview/Readiness Code
-
End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the Ground activation was not OK:
-
Replace the Motronic Engine Control Module (ECM) J220.
-
Assembly is performed in the reverse of the removal.
Final procedures