TT Quattro Coupe V6-3.2L (CBRA) (2008)
Valve Cover: Service and Repair
Cylinder Head Cover
Cylinder Head Cover
Removing
-
Remove intake manifold. See: Intake Manifold
-
Remove bolts - arrows - and lay aside fuel line bracket.
-
Remove electrical wiring bracket from upper timing chain cover.
-
Loosen cylinder head cover bolts in - 11 to 1 - sequence.
-
Remove bolts and remove cylinder head cover.
Installing
‹› Tightening specifications, refer to => [ Cylinder Head and Cylinder Head Cover Assembly Overview ] See: Cylinder Head and Cylinder Head
Cover Assembly Overview, => [ Cylinder Head Cover - Tightening Specifications
and Tightening Sequence ] See: Cylinder Head and Cylinder Head Cover Assembly Overview
Installation is in reverse order of removal, note the following:
‹› Replace cylinder head cover seals and bolts if damaged.
-
Tighten cylinder head cover bolts. Refer to => [ Cylinder Head Cover - Tightening Specifications
and Tightening Sequence ] See: Cylinder Head and Cylinder Head Cover Assembly Overview.