TT Quattro Coupe V6-3.2L (CBRA) (2008)
-
To prevent surface damage to intake manifold, lay a clean cloth - 1 - over lock carrier.
-
Tip intake manifold forward - arrow A - and remove it to left - arrow B -.
‹› Seal intake channels in cylinder head with clean rags or foam pieces so that small pieces cannot fall in.
Installing
‹› Tightening torques => [ Intake Manifold Assembly Overview ] See: Intake Manifold Assembly Overview.
Installation is in reverse order of removal, note the following:
‹› Replace seals.
-
Install ignition coils => [ Ignition Coils ] See: Powertrain Management/Ignition System/Ignition Coil/Service and Repair.
-
Install air filter housing => [ Air Filter Housing ] See: Tune-up and Engine Performance Checks/Air Cleaner Housing/Service and Repair.
-
Install air filter insert => [ Air Filter Insert ] See: Tune-up and Engine Performance Checks/Air Cleaner Housing/Air Filter Element/Service and
Repair/Air Filter Insert.
-
Connect Ground (GND) wire to battery => Electrical
Equipment 27 Removal and Installation.