TT Quattro Coupe V6-3.2L (CBRA) (2008)
![background image](/audi/tt_quattro_coupe/v6-3.2l_(cbra)/Page-3024001.png)
Tail Lamp: Service and Repair
Tail Lamp
Tail Lamp
Removing
-
Switch off ignition and remove ignition key.
-
Turn light switch into "0" position.
-
Fold cut out area - 2 - of luggage compartment forward.
-
Remove bolt - 3 -.
-
Slide the tail lamp - 1 - toward outside - arrow - and disengage from retaining pins on body.
-
Disconnect electrical harness connector at lamp carrier.
Installing
‹› Tightening specification, refer to => [ Tail Lamp Assembly Overview ] See: Tail Lamp Assembly Overview.
Install in reverse order of removal, observing the following:
‹› Make sure seal between body and tail lamp housing seals properly.
-
Position tail lamps on retaining bolts from outside and press on in direction of vehicle center until it locks.