TT Quattro Coupe V6-3.2L (CBRA) (2008)
Attaching brass pin contact to fiber optic cable
-
Open securing lever on Crimping Pliers For Fiber-optic Cable VAS 6223/2 - arrow 1 - and - arrow 2 -.
-
Insert brass pin contact - 1 - in mount.
-
Close securing lever on Crimping Pliers For Fiber-optic Cable VAS 6223/2 - arrow -.
-
Slide fiber optic cable - 2 - into brass pin contact - 1 - as far as spring-loaded stop.
-
Slide fiber-optic cable further in up to fixed stop and close Crimping Pliers For Fiber-optic Cable VAS 6223/2.
-
Open Crimping Pliers For Fiber-optic Cable and remove fiber-optic cable with brass pin contact.
CAUTION: Do not excessively bend or kink fiber optic cables. (min. bending radius 25 mm).
-
Check proper attachment of brass pin contact - 2 - to fiber optic cable - 1 -.
-
4 crimp points must be visible at brass connection pin.
-
The brass pin contact must not be able to be removed by hand from fiber-optic cable.