TT Quattro Coupe V6-3.2L (CBRA) (2008)
![background image](/audi/tt_quattro_coupe/v6-3.2l_(cbra)/Page-930003.png)
Specified value: Battery voltage.
If the specification was not obtained:
-
Check the Heated Oxygen Sensor (HO2S) (G39) electrical harness connector terminal 4 to the Fuel Pump (FP) 2 Relay (J49) socket 2/87 an open
circuit, a short circuit to each other, Battery (+), or Ground (GND).
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
-
If necessary, repair the faulty wiring connection.
If the specification was obtained:
Checking Ground (GND) activation
If the manufacturers test box is being used. Perform the following step.
-
Install the test box. See: Engine Control Module/Testing and Inspection/Engine Control Module
If the manufacturers test box is not being used. Perform the following step.
-
Remove the Engine Control Module (ECM) (J623). Refer to => [ Engine Control Module, Replacing ] See: Engine Control Module/Testing and
Inspection/Engine Control Module.
-
Using a multimeter, check the Heated Oxygen Sensor (HO2S) electrical harness connector to the Engine Control Module (ECM) (J623) electrical
harness connector T81 for resistance.