TT Quattro Coupe V6-3.2L (CBRA) (2008)
CAUTION!
Do not use other grease under any circumstances.
-
Place cover on as marked during removal (Fig. ).
-
Install new bolts and tighten them to the specification.
Tightening specifications, refer to => [ Electro-Mechanical Power Steering, Servicing Assembly Overview ] See: Service and Repair/Removal and
Replacement
-
Remove excess grease on cover of steering pinion and on steering pinion.
Further installation is in the reverse sequence to removal.
-
Steering gear, installing. Refer to => [ Electro-Mechanical Steering Gear ] See: Electro-Mechanical Steering Gear.
-
Perform vehicle alignment, refer to => [ Measurement Procedure ] See: Alignment/Service and Repair/Measurement Procedure.
-
Perform basic setting for steering angle sensor ( G85) via => Vehicle Diagnosis, Testing and Information System (VAS 5051B), "Guided Fault
Finding".
-
Then perform basic setting of steering system via => Vehicle Diagnosis, Testing and Information System (VAS 5051B ) "Guided Fault Finding".