TT Quattro Coupe V6-3.2L (CBRA) (2008)
/Page-1254001.png)
Constant Velocity Joint: Service and Repair
Rear Suspension
Drive axle (with 100 mm diameter inner constant velocity joint), servicing
Filling joints with grease
Note:
^
Grease joint again when replacing protective joint boot.
1. Outer constant velocity joint
2. Bolt
^
200 Nm plus an additional 1/2 turn (180 degrees)
^
Always replace after removal
3. Axle shaft
4. Clamp
5. CV boot for outer constant velocity (CV) joint
6. Clamp
^
Replace
^
Tensioning or
7. Dished washer
^
Installed position
8. Spacer ring (plastic)
^
Installed position
9. Securing ring