TT Quattro Coupe V6-3.2L (CBRA) (2008)
-
Using bolts -arrows-, align protective boot and cap with bolt holes.
It must be aligned exactly because it cannot be aligned after driving on.
-
Drive off protective boot with cap using plastic hammer.
-
Clear away leaking sealing immediately.
Stainless steel clamps for Hytrel protective joint boots, tensioning
-
Position CV Joint Boot Clamp Tool VAG1682 as shown in illustration. Be sure that edges of clamping pliers are seated in corners - arrows B - of
hose clamp.
-
Tighten hose clamp by turning spindle -A- using a torque wrench (do not tilt clamping pliers).
^
Tightening torque: 20 Nm
Note:
^
Be sure thread of spindle in clamping pliers moves freely. Grease with MOS2 grease, if necessary.
^
If it does not move freely, e.g. due to dirt in thread, the required clamp tension will not be achieved at the specified torque.
Clamps for rubber protective joint boots, tensioning