TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
Roll Bar: Service and Repair
Crossmember For Roll Bar, Removing and Installing
Crossmember For Roll Bar, Removing And Installing
1
-
Crossmember for roll bar
-
Removing
-
Remove both roll bars
-
Remove speaker assembly carrier
-
Remove wind deflector or trim panel in place of wind deflector.
-
Lift cover up slightly
-
Remove protective covers for bolts - 4 -
-
Remove bolts - 4 - (2x).
-
Remove bolts - 3 - (2x).
-
Remove bolts - 2 - (8x).
-
Take roll bar crossmember - 1 - from vehicle.
-
Installing
NOTE:
-
Tighten bolts in following sequence.
-
Bolt - 3 - with centering unit.
-
Arrow points toward front of vehicle.
-
Install bolts - 3 -.
-
Install bolts - 4 -.
-
Install bolts - 2 - diagonally.
-
Before installing roll bar, check to be sure rubber guide is properly seated
-
Perform installation in reverse order of removal.
2
-
Bolts (8x)
-
Tightening torque 20 Nm