TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
Connect lines as previously marked:
A - Secondary piston circuit
B - Primary piston circuit
1 - To right front brake caliper
2 - To left rear brake caliper
3 - To right rear brake caliper
4 - To left front brake caliper
-
Install connector on hydraulic pump.
-
Bolt ABS control module to bracket.
Note: Do not fully tighten bolts. This facilitates attachment of individual brake lines to hydraulic unit.
-
After tightening brake lines, tighten hydraulic unit.
-
Bleed brake system
-
If a new control module has been installed it must be coded.
-
After connecting brake lines to hydraulic unit, perform final control diagnosis.
Note: Final control diagnosis can be used to establish whether line connections have been interchanged.
Tightening torques