TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
Brake Caliper: Service and Repair
Rear Brake Caliper, Servicing
Rear brake caliper, servicing
Note:
^
Install complete repair kit when performing service work.
^
New brake calipers are filled with brake fluid and pre-bled.
^
Apply thin coat of assembly paste G 052 150 A2 to brake cylinder, piston and sealing ring.
^
When performing repair work, always pre-bleed brake calipers.
Rear brake caliper
Exploded view
1. Bolt - 35 Nm
^
Self-locking
^
Replace each time after removing
^
When loosening and tightening counterhold on guide pin
2. Bleeder screw - 10 Nm
^
Apply thin coat of assembly paste G 052 150 A2 to threads before screwing in
3. Protective seal
4. Guide pins
^
Grease before pulling on protective cap
5. Protective cap
^
Pull onto brake carrier and guide pin
6. Brake carrier with guide pin and protective cap
^
Supplied as replacement part, assembled with sufficient grease on guide pins
^
If protective caps or guide pins are damaged, install repair kit. Use grease packet supplied to lubricate the guide pins.
7. Protective cap
^
Pull outer sealing lip onto piston
8. Piston with automatic adjustment
9. Seal