TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
Braking Sensor/Switch: Service and Repair
Square Housing
Brake light switch (square housing), removing and installing
Note: To ensure a secure fit, the switch may only be installed once.
Removing
-
Remove storage compartment on driver's side.
-
Unplug electrical connector.
-
Remove brake light switch -1- by turning counter-clockwise through 90°.
Installing
Install in reverse sequence; note the following points:
-
Pull brake light switch plunger fully out.
-
Press brake pedal down as far as possible by hand.
-
Guide switch through installation hole and secure by turning 90° clockwise -arrows-.
-
Release brake pedal.
-
Make sure proper function of brake lights when brake pedal is pressed and released.