TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
-
Connect multimeter for voltage measurement as follows:
Harness connector
Specified value
Terminal
1 + Ground (GND)
about 5 V
1 + 5
about 5 V
2 + Ground (GND)
about 5 V
2 + 3
about 5 V
If specified values are obtained:
-
Also check signal wires.
If specified values are not obtained:
-
Check wire connections from Engine Control Module (ECM) to sensors for accelerator pedal position.
Checking wire connections
-
Connect VAG1598/31 test box at wiring harness to ECM, do not connect ECM. See: Computers and Control Systems/Testing and Inspection/Scan
Tool Testing and Procedures/Scan Tool Testing/Scan Tool Connecting and Initial Checks/Wiring and Component Testing Using VAG1598/31
Test Box
-
Check the following wire connection for open circuit and short circuit to Ground (GND) and B+:
Harness connector
VAG1598/31 test box
Terminal
Socket
1
72
2
73
3
36
4
35
5
33
6
34
-
Repair open circuit or short circuit if necessary.
If no malfunctions are found in wires:
-
Replace accelerator pedal position sensor.