TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
You will receive automatic weekly parts allocations based on each week's owner notification mailings to owners located within your area of
responsibility. Do not place an order on your own until further notice.
NOTE:
All part numbers shown above are considered production level parts and do NOT need to be replaced.
Work Procedure
Objective:
This procedure describes changing ignition coils on 1.8 liter 2.7 liter & 3.0 liter engines in Audi TT, A4, and A6 vehicles.
Special Tools
-
Puller T40039 - must be used to avoid damaging ignition coils during removal
Work Sequence:
Section A - 1.8 liter engine in Audi TT and A4 vehicles
Section B - 3.0 liter engine in Audi A4 and A6 vehicles
Section C - 2.7 liter bi-turbo engine in Audi A6 and Allroad vehicles
Section A - 1.8 Liter Engine in Audi TT and A4
IMPORTANT:
If the vehicle has a MIL light on, the diagnostic trouble codes (DTCs) must be checked. Only cylinder misfire DTCs related to ignition coil
malfunction are covered by this service action. Any other checking, diagnosis or repairs are not covered under this service action.
-
If applicable, connect VAS5051 and check DTCs
-
Open hood and remove engine cover
-
Check type of ignition coil