TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
Steering Angle Sensor: Service and Repair
ABS/ESP ITT Mark 60
Steering angle sensor -G85-, removing and installing
Note: The coil connector with slip ring is enclosed in the housing of the steering angle sensor -G85-.
Removing
^
Turn wheels to straight ahead position.
^
Removing airbag unit and steering wheel.
^
Remove storage compartment on driver's side.
^
Remove bolts -1- and detach handle for steering column adjustment -5
^
Remove bolts -2- to -4-.
^
Remove upper and lower sections of steering column trim.
^
Disconnect electrical connectors -1- and -2-.
^
Carefully lift upper retainer tabs -arrows-.
^
Carefully lift lower retainer tabs and pull off housing with coil connector, slip ring and steering angle sensor from steering column switch.
Installing
Install in reverse sequence; note the following points:
^
Push on housing with coil connector, slip ring and steering angle sensor onto steering column switch until all retainer tabs engage with a click.
^
Break off transportation protection.