TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
-
Place front and rear bearing tool - 1 - on rear side of wheel bearing housing.
-
Attach hollow piston cylinder - 2 - with tie bolt - 3, special nut - 4 - and front and rear bearing tool - 5 -.
-
Build pressure by pumping foot pump.
-
Check to make sure all tools are properly centered.
-
Press in wheel bearing by pumping.
1 - Front and rear bearing tool E - 6 - 1
2 - Hollow piston cylinder HKZ- 15
3 - Tie bolt E-0-217
4 - Special nut E - 8 - 214
5 - Front and rear bearing tool E - 13 - 1
-
Always install securing ring.
Pressing in wheel hub
-
Place wheel hub on wheel bearing.
-
Attach centering unit with clamp E - 76 - 2.
Removing bonded rubber bushing from longitudinal control arm