TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
-
Turn stop - A - for clutch pedal in direction of arrow and remove.
-
Then press master cylinder in direction of arrow -
1. to stop first. It must not be covered in upper area by over - center spring mounting (arrow 2).
-
Then swing it in direction of arrow 3 out of mounting bracket.
Installing
Installation is carried out in the reverse sequence, when doing this note the following:
-
The retainer - A - must be fitted to the master cylinder operating rod - B -.
-
Press clutch pedal in direction of arrow to engage. Ensure correctly located.
-
Fit stop - A - for clutch pedal.
Installation position:
The arm (arrow) points toward master cylinder - B -.
-
Bleeding clutch system after installing master cylinder, Refer to Clutch, M/T, Service and Repair.