TT Quattro Roadster L4-1.8L Turbo (AMU) (2002)
Notes: The engine and transmission will move forward slightly when the bolts - A - are loosened (Fig. N34-087, Refer to Drive/Propeller Shaft.
Take care not to damage seal (arrow) in driveshaft flange when removing and installing.
-
Unbolt pendulum support from subframe (arrows - A -).
-
Press engine/transmission forward carefully.
-
Unbolt flexible coupling from flange on bevel box (arrows).
-
Now carefully remove flexible coupling.
Installing
Installation is carried out in the reverse order, when doing this note the following:
^
All parts of the driveshaft marked must be reinstalled in the same positions in relation to each other.
^
First insert driveshaft bolts into flexible coupling, then bolt flexible coupling onto bevel box.
Installation position:
^
The open side of the heat shield should be toward the bevel box.
^
Three projecting sleeves on the transmission flange and driveshaft flange engage in the mounting holes in the flexible coupling.