TT Quattro Roadster V6-3.2L (BHE) (2005)
/Page-1422002.png)
-
Remove brake pads and pad retaining springs - arrows -.
Note:
^
If reusing brake pads mark location and install in same position when installing, otherwise it will cause uneven braking!
Installing
Install in reverse sequence; note the following points:
-
Clean brake caliper housing, in particular the bonding surface for the brake pad. It must be free of adhesive and grease residues.
Use methylated spirit only for cleaning the brake caliper housing.
Note:
^
Prior to pressing the piston back, draw off brake fluid from the reservoir. Use a bleeder bottle or a plastic bottle which is only used for brake
fluid.
CAUTION
Brake fluid is poisonous and must under no circumstances be siphoned via a hose with the mouth.
-
Apply special tool 3272 together with 3272/1 to piston on brake caliper housing.
-
Screw in piston by turning knurled wheel of Resetting and extracting tool VAS 3272 clockwise, do not damage protective cap when doing this.
Note:
^
If piston is stiff, use a 13 mm open-ended wrench to be applied at appropriate flats - arrow -.
