TT Quattro Roadster V6-3.2L (BHE) (2005)
Fluid - A/T: Removal and Replacement
Gear Oil Level, Checking
Gear oil level, checking, 02E, 6 Speed Direct Shift A/T, AWD
CAUTION!
^
The engine must not be started if significant oil loss has occurred (e.g. during repairs) and there is little or no oil left in the transmission.
^
If necessary, perform a pre-filling of gear oil for the direct shift transmission.
^
Only the gear oil for the direct shift transmission (available as a replacement part) may be used for the direct shift transmission 02E.
Other oils cause faults and/or failure of the transmission.
^
Gear oil part number.
^
Transmission must not be in emergency running (backup) mode.
^
Vehicle must be level (horizontal).
^
Selector lever at position "P".
^
Engine idling.
^
Air conditioning and heating system switched off.
^
Vehicle diagnostic, testing and information system VAS 5051 connected; vehicle self-diagnosis and vehicle system "02 - Gearbox electronics"
selected.
^
The gear oil temperature at the beginning of the test must not be higher than 30°C. If necessary, first allow the transmission to cool down.
Note:
^
The gear oil temperature is taken from the reading on the vehicle diagnostic, testing and information system VAS 5051.
^
The gear oil level will vary according to the gear oil temperature.
^
If the gear oil level is checked when the gear oil temperature is too low, this will result in overfilling.
^
If the gear oil level is checked when the gear oil temperature is too high, this will result in underfilling.
^
Both overfilling and underfilling have a detrimental effect on the functioning of the transmission.
Reading gear oil temperature
Indicated on vehicle diagnostic, testing and information system VAS 5051:
-
From list - 1 - select diagnostic function "08 - Read measured value block".
Indicated on vehicle diagnostic, testing and information system VAS 5051:
1 -
Enter display group (max. input value = 255).
-
Use keypad - 2 - to enter "19" for "Display group number 19" and confirm by touching Q key.