TT Quattro Roadster V6-3.2L (BHE) (2005)
^
Disconnect air hose -2- from mass air flow sensor.
^
Unplug connector -3- from mass air flow sensor.
^
Unscrew bolts -4- and -5-.
^
Remove air cleaner housing.
^
Lay out sufficient lint-free cloths in area below brake master cylinder to catch escaping brake fluid.
^
Draw off as much brake fluid as possible from brake fluid reservoir using brake filler and bleeder unit VAS 5234.
^
Pull connector off relevant pressure sender (the one to be removed) -arrows-.
a - Sender 1 for brake booster -G201- in primary piston circuit
b - Sensor -2- for brake pressure -G214- in secondary piston circuit
^
Remove brake pressure sender.
Installing
Install in reverse sequence; note the following points:
^
Bleed brake system
^
Bleed hydraulic system for clutch
^
Initiate basic settings for brake pressure sensors. See: Adjustments
^
Perform ESP road test.
Tightening torques