TT Quattro Roadster V6-3.2L (BHE) (2005)
Shift Cable: Service and Repair
Selector lever cable, removing and installing, 02E, 6 Speed Direct Shift A/T, AWD
Removing
CAUTION! Follow steps required when disconnecting battery.
Note: The battery is located in the rear compartment, in the spare wheel well.
-
Disconnect ground strap on battery (in rear compartment) with ignition switched off.
-
Loosen clamp - 4 - and disconnect intake hose and connector - 1 - from mass air flow sensor.
-
If installed, disconnect hose - 5 - from air cleaner housing.
-
Remove bolts - 2 - and - 3 - and remove complete air cleaner housing.
-
Shift selector lever into "P" position.
-
Remove locking plate - C -.
-
Push circlip - A - upward and remove it in direction of arrow.
-
Press selector lever cable off selector shaft lever in direction of arrow and place on top.
Note:
^
Do not loosen bolt - B -.
^
Do not kink selector lever cable.
-
Unhook selector lever cable - 1 - from clip - arrow - on transmission.
-
Raise vehicle.