audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Removal and Replacement > < Selector Mechanism, Servicing|Page 3642
Page 2
background image

-

Carefully press selector lever cable onto selector shaft lever (in opposite direction of arrow).

-

Install circlip - A - and press downward to secure.

Selector lever cable, adjusting 

-

Shift selector lever into "P" position.

-

Loosen bolt - B -.

-

Bring selector shaft lever in position "P" on transmission.

-

Turn both front wheels in one direction, e.g. by pushing vehicle forward, until detent lever in transmission engages in parking lock gear and wheels
are blocked (it is not possible to turn them both in same direction simultaneously).

Note:  The selector lever must be in "P" position when the clamping bolt - B - is loosened; otherwise, the adjustment will not be correct.

-

Carefully move selector lever slightly forward and backward, without shifting lever into a different selector lever position.

-

Tighten bolt - B - smoothly and evenly (tightening torque: 13 Nm).

Note:  When tightening bolt - B -, make sure the selector lever cable does not move out of position.

-

Follow steps required after connecting battery.

Selector lever cable, checking adjustment 

-

Keep button pressed, while pulling selector lever approx. 5 mm to rear out of "P" position. Then keep lever in this position, do not move it into
"R".

-

Release selector lever.

Selector lever must spring back into "P" position automatically.
-

If necessary, adjust selector lever

-

Shift selector lever into position "N".

-

Keep button pressed, while pulling selector lever approx. 5 mm to rear out of "N" position. Then keep lever in this position, do not move it into
"D".

-

Release selector lever.

Selector lever must spring back into "N" position automatically.
-

If necessary, adjust selector lever

-

Keep button pressed, while pushing selector lever approx. 5 mm to front out of "N" position. Then keep lever in this position, do not move it into
"R".

-

Release selector lever.

Selector lever must spring back into "N" position automatically.
-

If necessary, adjust selector lever

-

Check selector mechanism.

Removal and Replacement > < Selector Mechanism, Servicing|Page 3642