TT Roadster L4-1.8L Turbo (AWP) (2003)
Hood Shock / Support: Service and Repair
Gas-filled Strut, Removing And Installing
-
Press spring clips - 5 - slightly back at respective end using a screwdriver and pull gas-filled strut - 2 - off of ball stud.
-
Rear lid stop - 3 -.
-
Lid hinge - 4 -.
NOTE: When removing or installing the gas-filled strut, push back the opened rear lid only slightly so as to avoid damaging components.
Installing:
NOTES:
-
Following complete removal of the gas-filled strut, check for correct positioning during installation.
-
Attach tube end of strut at the rear lid.
-
Clip in gas-filled strut at bottom first, then at top.
-
To install, simply press gas-filled strut onto ball studs so that it engages in position.
-
Ball stud tightening torque: 15 Nm - 1 Nm