TT Roadster L4-1.8L Turbo (AWP) (2003)
- Carefully pull away side-airbag unit - 2 - outward.
-
Installing
NOTE: Always replace screw - 4
- Position side-airbag unit - 2 - so locking pins - 3 - engage in holes - 7 -.
- Push side-airbag unit up as far as it will go.
- Tighten newly replaced screw - 4 - on side-airbag unit to 10 Nm (7 ft lb).
- Route airbag cable - 5 - so that it is seated correctly in the clips and routed according to illustrations.
- Remainder of installation is carried out in reverse order of removal.
- Switch ignition on.
WARNING: Make sure no one is in vehicle when connecting battery.
- Connect battery Ground (GND) strap.
3
-
Locking pins
4
-
Screw
-
Tightening torque: 10 Nm (7 ft lb)
5
-
Airbag cable
6
-
Fastener
7
-
Engaging holes
NOTE:
-
After connecting battery, check vehicle equipment (radio, clock electric windows) as per Owner's Manual.
-
If the airbag malfunction indicator lamp (K75) signals a malfunction after repairs are completed, then DTC memory must be erased and checked
again using VAG1551 scan tool.