TT Roadster L4-1.8L Turbo (AWP) (2003)
^
If protective sleeve is damaged, selector lever cable must be replaced
^
Do not lubricate cable eye and ball socket
10 -
Locking plate
^
For selector lever cable at bearing cup
^
Always replace
11 -
Self-locking nut, 10 Nm
^
For cover at mounting bracket
^
Qty. 4
^
Always replace
12 -
Cover
^
For mounting bracket
^
With bonded-on gasket
13 -
Bolt
14 -
Locking plate
^
For pivot pin Item - 16 - of locking pawl Item - 15 -
15 -
Locking pawl
^
For selector lever lock
^
Engages in cable lever of mounting bracket
16 -
Pivot pin
^
For locking pawl
17 -
Shift lock solenoid - N110 -
^
Can be replaced with shift mechanism installed
^
Can be checked using VAS 5051 in Guided fault-finding
18 -
Locking cable
^
For ignition key removal lock
^
Must not be kinked
19 -
Mount
20 -
Steering lock
21 -
Clamp
^
Installation position: Install clamp from above. Angled ends of clamp point toward steering lock
Fig. 1 Installation position of printed circuit board
-
Position printed circuit board with its holes on guides of frame (arrows).
-
Clip wiring harness -A- into frame ensuring that printed circuit board does not become deformed.