TT Roadster L4-1.8L Turbo (AWP) (2003)
/Page-2773011.png)
-
Connect connectors - 2 - and - 6 - on valve body -D- to 7 Nm (M5 bolts).
Note:
^
If the wire - 3 - (to sensor - G182 -) is too short to be able to fasten the connector - 2 - at the specified location on the valve body, it has been
routed incorrectly or is being pinched by the valve body. The valve body must be removed again and the wire must be routed correctly.
^
Pinched wires must be replaced.
-
Engage wiring harness -B- in bracket -C- and route it as illustrated.
-
Install ATF screen.
-
Install oil pan.
-
Connect battery:
-
Fill with ATF, check ATF level and top off.
Tightening torque