TT Roadster L4-2.0L Turbo (BPY) (2008)
Cowl Moulding / Trim: Service and Repair
Fresh Air Intake Cover
Fresh Air Intake Cover
Preparation
-
Remove windshield wiper arm.
-
Remove rubber seal - 1 - and remove plenum chamber cover - 2 - by carefully pulling it off retainers on windshield.
Checking
-
Ensure fresh air intake cover - B - is installed correctly and is not damaged.
Removing and Installing
-
Perform the preliminary work.
-
Remove bolts - A - (tightening specification: 2.5 Nm).
-
Remove cover - B -.
Installation is done is reverse order, observe the following:
‹› Before installing, check bonded seal and cover - B -, replace a damaged seal or cover.
‹› When installing, ensure cover - B - and accompanying seal are seated correctly. If cover is not installed correctly, water can run into the A/C unit
air intake shroud.