TT Roadster L4-2.0L Turbo (BPY) (2008)
Headlamp Alignment Actuator: Service and Repair
Halogen Headlamps
Left And Right Headlamp Beam Adjustment Motors V48 / V49 , Removing And Installing
Removing
-
Remove headlamp.
-
Release spring clip - arrow - and remove low beam bulb housing cover - 1 - from headlamp housing.
-
Remove screws - arrows -.
-
By swivelling control motor - 1 -, push ball end of positioning stem downwards out of socket.
-
Press reflector forward and remove adjusting motor.
-
Unplug electrical connection - 2 -.
Installing
-
Tightening torque.
Install in reverse order of removal, noting the following:
-
First reconnect connector and insert adjusting axle ball head into reflector ball head mount from below by pulling reflector back.
NOTE: The headlamps must be adjusted if the adjusting motors are removed and installed or replaced.
-
Close housing lid.
-
Secure housing cover using wire clamp.
-
Install headlamp.