TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Heat crimp connection using hot air gun lengthwise from center outward until it is sealed completely and adhesive comes out the ends.
-
This is how the completed repair location with the inserted wire and two crimp connectors should look.
NOTE:
-
Make sure that crimp connections do not lie directly next to each other when several wires need to be repaired. Arrange the crimp
connectors at a slight offset so that the circumference of the wiring harness does not become too large.
-
If the repair point was previous taped, this point must be taped again with yellow insulating tape after repairs.
-
Secure the repaired wiring harness if necessary with a cable tie to prevent flapping noises while driving.