TT Roadster L4-2.0L Turbo (BPY) (2008)
2.
The position of a clip on the harness must be checked and corrected, as shown in Figures 6 and 7.
a.
Check to see that there is 3/4 in. between the wiring harness clip and the plastic T-piece where the wiring branches off to the secondary air
solenoid (Figure 7).
b.
Open the harness clip (Figure 8).
c.
Move the harness in the clip so there is 3/4 in. between the harness T-piece and clip as shown in Figure 7. Refasten clip.