TT Roadster L4-2.0L Turbo (BPY) (2008)
-
Push the (T10238) into the intended openings - arrow - as far as the stop, as shown, and remove the accelerator pedal module.
Installing
‹› Tightening specifications. Refer to => [ Accelerator Pedal Module, Version 2 Assembly Overview ] See: Accelerator Pedal Module, Version 2
Assembly Overview.
Installation is in reverse order of removal, note the following:
-
Connect the connector - 2 - on the accelerator pedal module - 5 -.
‹› The connector must engage audibly.
-
Push the accelerator pedal module onto the securing studs - 6 -.
-
Insert the centering pin - 7 - into the hole on the underbody.
-
Secure the accelerator pedal module with the bolt - 3 - and install the cap - 4 -.