TT Roadster L4-2.0L Turbo (BPY) (2008)
Module (ECM) (J623).
-
Using a Multimeter, check the Intake Air Temperature (IAT) Sensor (G42 ) electrical harness connector terminals to the Engine Control Module
(ECM) ( J623) electrical harness connector T60 terminals for resistance.
Specified value: 1.5 ohms Max.
If the specification was not obtained:
-
Check the wiring for a short circuit to each other, Battery (+), and Ground (GND).
-
If necessary, repair the faulty wiring connection.
-
Check the electrical harness connector for damage, corrosion, loose or broken terminals.
If no malfunction is detected in the wiring:
-
Erase the DTC memory. Refer to => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 04 - Erase DTC Memory.
-
Perform a road test to verify repair.
If the DTC does not return:
Repair complete, Generate readiness code. Refer to => [ Readiness Code ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness
Codes.
-
End diagnosis.
If the DTC does return and no malfunction is detected in the wiring and the voltage supply was not OK:
-
Replace the Engine Control Module (ECM) (J623 ). Refer to => [ replacing ] See: Engine Control Module/Testing and Inspection/Engine Control
Module (ECM) (J623).
-
Assembly is performed in the reverse of the removal.
Final procedures
After the repair work, the following work steps must be performed in the following sequence:
1. Check the DTC memory. Refer to => [ Diagnostic Mode 03 - Read DTC Memory ] See: Testing and Inspection/Scan Tool Testing and
Procedures/Diagnostic Modes 01 - 09/Diagnostic Mode 03 - Read DTC Memory.